What topics would you like to discuss?

Mark Maleski

Mark Maleski

Administrator
As of this writing, we have covered initial introductions and shared some of the unplugged hand tools that members have made. Our next meeting will focus on technique: how would you use hand tools to create a rabbit/rabbet/fillister on the end of a board?

What other topic ideas are out there?
 
Here are some possibilities:
1. Cross band veneer faced edges on a drawer front.
2. Fitting a bread board end to a cross grain tenoned board and allowing for stock movement (such as a slant front desk lid.)
3. Fitting a beaded drawer rail with a tenon end into a mortise hole of a beaded stile on a case frame.
4. Shaping an OG mold or a thumbnail molded edge on a radius table-top edge.

Wes.
 
You must log in or register to reply here.
Back
Top